Firmware version 3 and later uses a HID interface for communication. Gets enumerated as USB device: Both drivers will be under “Jungo Connectivity”. The actual drivers are the entries of this drop-down. Yes it does, I am able to see it in the programming dialog of studio 5.

Uploader: Dulabar
Date Added: 5 May 2009
File Size: 10.80 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 32676
Price: Free* [*Free Regsitration Required]

This site uses cookies.

Setting up the AVR Jungo USB Driver manually

Is the issue specific to this device? As for your questions, this is only an issue with this particular device. Note Firmware version 3 and later uses a HID interface for communication. I would like to know some information about the issue so that we could help you better.

Now launch a command prompt with elevated privileges Right click cmd.

DeanP Replied on February 22, If issue still persists, then use suggestions in article given in method 3. Hello Dean, Thank junngo for posting your question on Microsoft Community. Sorry, your blog cannot share posts by email. I would suggest you to contact Atmel technical support. Then after completion go to the install location of Jungo.


This site in other languages x.

Hardware devices are not working or are not detected in Windows http: Jumgo all USB devices and then perform the following steps: Now some logs will appear and it should say succeeded. If so delete them.

Jungo Connectivity Driver

Instead, I have only “WinDriver” under “Jungo”. Thanks for taking the time to read through my question. Now inside that folder there will be two folders usb32 and usb64, since we are here for a Win 7 x64 cause we should use the usb64 folder.

So here is the story of it. Tips for solving problems with USB devices http: Now reboot the system. Some symptoms are as follows.

There is no attmel issue with WinDriver that requires uninstalling and then re-installing it. In reply to Ratandeep’s post on February 22, Then goto the usb64 folder from command prompt as administrator.

I assume that I did not sufficiently remove all the driver atmmel to trick my PC to re-installing the drivers as though this was my 1st attempt. Repeat the step 2 to uninstall all items under “Universal Serial Bus controllers”. According to the ATMEL discussion groups, this driver sometimes doesn’t install correctly on the 1st attempt, needs to be removed and re-installed.


AVR Jungo USB by Atmel – Should I Remove It?

By continuing to use this website, you agree to their use. In reply to Ian Bakshan’s post on February 24, If you are prompted for an administrator password or for a confirmation, type the password, or click Allow.

This is new territory for me. Hello, There is no known issue with WinDriver that requires uninstalling jumgo then re-installing it. Now check if things work, in some case you might be lucky.